Unlock the tractors by pulling forward on the tractor clamping levers. Replace the top cover. Pull up the tractors by pinching both tractor position shift levers and rotating the tractor upward. The interface connector is located on the back of the printer towards the left side. Slide the tractors out toward the sides and raise the tractor covers. The side on which you wish to print should face up. Not operational when the Control Table is not in the above mentioned positions If pressed, error sound will occur.
|Date Added:||21 February 2017|
|File Size:||38.63 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Unlock the tractors by pulling forward on the tractor clamping levers. The interface connector is located on the back of the printer towards the left side. Cut sheet feeder Part KX-P Font choices, for example, are of this type. Turn ;anasonic power off, wait a moment, then turn the power on to set top of form.
As you lift, release the rear levers, continue lifting until tractors snap into place. The change will not occur until the current line is finished.
Panasonic KX-P1124 Printer Ribbon Cartridges – KX-P145 Cartridges
Slide the tractors out toward the sides and raise the tractor covers. Epson LQ Italic Character set. Slide the top cover toward the rear of the printer as shown. Replace the top cover so that it is totally forward. Then they will be printed in draft mode for approximately 20 minutes. Align the p11124 paper support so that it is centered between the tractors. These key switches allow you to select various pwnasonic features and functions of the printer by setting the Control Table.
Enter or exists the Function mode. Visually insure the tractor pins are in the center of the paper sprocket holes.
Replace the top cover. If the tractor is in the “pull” position, push it down to the “push” position by pinching both tractor position shift levers and rotating the tractors downward. Insert the continuous fanfold paper through bottom slot and pull it up as shown. Open the paper door and begin to insert the paper by using the paper guide.
This indicates the printer is in the Initial Setup mode. Align the paper sprocket holes with tractor pins and close tractor covers.
Waiting for the redirectiron
Align the center paper support so that it is centered p112 the tracks. The printer will print between 0 and 80 on the scale. The side on which you wish to print should face up. Pull up the tractors by pinching both tractor position shift levers and rotating the tractor upward.
You can also insert the continuous fanfold paper through the front of the printer.
Panasonic KX-P1124 Impact Printer
Make sure the paper is straight. There are two types of selection: Align the paper horizontally without any slack, by using the mark son the smoked plastic cover as a guide. When the [ROW] switch is pressed, the row position will advance sequentially from 1st to 7th. Advancing the column setting will cause the column indicator light to blink at each alternate choice.
Press back on the tractor clamping levers locking the tractors in place. Rotate the platen know or use the [LF] switch to adjust the paper so that it is at the desired first print position.
Panasonic KX-P Printer Ribbon Cartridge and Printer Supplies at
Since only one font can be current, when one is chosen YES-column indicator light is litall others are “deselected” No-lights are OFF. To release the self test mode, turn the power switch off.
Bottom and front pull-tractor feed.